How to give Dimension (Distance and Bearing) in Surva CAD?


Whenever we use dimension command in Surva CAD, we should specify the style of dimensioning of individual line through the use of dimension code, which is an integer from 0 to 5, steps are as shown below.

1. Reset Scale according to your desire scale of drawing.



2. Click on Dim line tab (Give dim of a line with station circle) or Dim Full Line tab (Give dim of a line without station circle at end) or Dim 2 Point tab (Give dim of a line clicking 2 point of line)


3. Click on left side of line from middle going clockwise.



4. Dialogue box will appear, put the dim code 0 to 5 as required 


5. 

Code 0 if you want put bearing and distance centred of line on different sides.

Code 1 if you want put bearing and distance centred of line one above other

Code 2 if you want put bearing and distance spaced on one side of line.

Code 3 if you want put bearing and distance with forced arrow.

Code 4 if you want put forced arrow in of distance only.

Code 5 if you want put distance centred only no bearing.



6. ok

If you are going to use force arrow, you have click on line > put code > ok . click on either side of the line as indicated by dot and finally click enter to get dimension and bearing.



No comments

Powered by Blogger.